15” DRUM MACHINE MAINTENANCE
49
FEED CONTROL BAR
• Before starting to chip any wood, always
test the feed control bar. Make sure the
reverse, stop, and forward feed positions
work properly.
• Contact Carlton or an authorized dealer
immediately if the control bar doesn’t
work properly in any of the three
positions.
• ALWAYS VERIFY CORRECT
FUNCTION OF THE FEED
CONTROL BAR BEFORE
BEGINNING TO CHIP MATERIAL
• NO ONE SHOULD EVER REACH,
LEAN, OR KICK INTO THE FEED
INTAKE CHUTE WHEN THE
MACHINE OR THE ENGINE IS
RUNNING
• Grease the feed control bar every 30-40
hours of operation as needed. There is a
grease fitting on the end of each side of
the feed control bar.
• Apply a light coating of oil to the feed
control linkage weekly.
FEED CONTROL LINKAGE
To Next Page
Loading...
