7
MIXER OR TAP INsTAllATION
Step 1 – Preparation for mounting
the mixer or tap
Shut off water supply and remove
the hexagonal nut, the disc and
the gasket. Do not remove the
O-ring from the base of the mixer
or tap.
Step 2 – Installing the mixer
or tap
1. Insert the inlet connection
end of each flexible tail
through the hole in the deck
then place tap over deck
hole. Make sure the O-ring
is located between the deck
and the bottom of the mixer
or tap.
2. Slide the gasket and disc
onto the threaded stud then
screw on the hexagonal nut
and tighten.
To Next Page
Loading...
