8
MIXER OR TAP INsTAllATION
Step 3 – Connecting the water supply
1. a. Flush lines, t lter washer and connect
the exible tail to the water supply and
tighten to compress the sealing washer to
provide a watertight joint.
b. For models with temperature control
connect the red exible tail to the hot water
supply and the blue exible tail to the cold
water supply.
Important: Flexible tails must not be kinked,
twisted or in tension when installed. (Minimum
bend radius = 50mm). Do not install exible
tails where subject to ultra violet light.
2. Turn on the central water supply and the isolating stop taps.
3. Check for leaks.
Step 4 - Connecting the power source
1. Connect the power source:
a. For battery versions: Insert 1 x 9V battery into Dual Input
Power Box (see page 13 for details). Install the battery’s
box at the wall underneath the basin using the two sided
adhesive foam tape. The cable connection must point
down.
b. For mains option: Insert 1 x 9V battery into Dual Input
Power Box (see page 13 for details). Remove protective
rubber cap then connect the Transformer.
c. Connect the motor connector to the power source connector. Please note that since the
connector is water proof, some friction might apply. Important: push in the connector so that the
white o-ring is not visible and a clicking sound is heard. If not connected properly, the motor will
work continuously.
2. Wait a few seconds before activating the mixer or tap.
3. If the range is unsatisfactory, refer to the section titled “Settings adjustment”.
Battery option Mains option
O-ring visible – not connected
Connected properly so that only
the grooves are visible
To Next Page
Loading...
