IS1393 C PAGE 4 OF 4
Default: DISABLED.
A new water saving mode “Smart Flush” is available
to minimise the product’s water usage.
During normal use (i.e.: a minimum of 10 minutes
between uses) the water will flush after every use.
With Smart Flush mode enabled, the unit will monitor the
use of the urinal. If the unit detects a higher usage rate
during the period, the unit will:
On the next immediate use, activate a flush.
Any subsequent use within a 10 minute period,
activate a flush.
Then, if no further flushes occur after 10 minutes,
a flush will only be activated after 1 hour or 20
uses (whichever comes first).
• “Smart Flush” mode can be manually ENABLED or
DISABLED by pressing and holding the button
for 10 seconds. The indicator LED will flash at 5
seconds, and again at 10 seconds.
• Release the button.
• The indicator LED will indicate confirm that the
“Smart Flush” Mode is: ENABLED (1 LONG flash) or
DISABLED (2 SHORT Flashes).
RESET : Factory Default Settings
This function will restore the unit to the factory preset
defaults.
• Press & HOLD both buttons i.e.: +
SIMULTANEOUSLY for 5 seconds.
• The LED will flash once.
• Release the buttons.
• The indicator LED will flash 2 times to acknowledge
that the unit has been reset to the default settings.
Default Settings:
Flush Volume: 0.8 l/flush
Inlet Pressure: 300 kPa
Usage Duration: Short (5 seconds)
Stadium Mode: ENABLED
Smart Flush Mode: DISABLED