EasyManua.ls Logo

Carp Design V70 - Page 11

Carp Design V70
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
same time.
2 Control the boat on the water level by using the right rocker of the remote
controller. Dial up to forward, dial down to back, dial left to turn left at the
origin, dial right to turn right at the origin, dial left up to turn left, and dial
right up to turn right.
3 The toggle switch in the upper left corner of the remote control is the front
and rear lights switch of the boat, which is off if it is pushed upward, low
brightness if it is pushed to the middle, and high brightness if it is pushed
downward.
4 The switch in the upper right corner of the remote control is for the course
protection program, which is turned off when turned up and turned on
when turned down. When this switch is turned on, the boat automatically
corrects course and follows a straight line.
5 The left up knob of the standard remote controller is the optional throwing
range adjustment knob of the bait thrower, it be adjusted counterclockwise
to control the range from small to wide. An operation protection program is
used to prevent incorrect opening of the bait thrower. When the remote
controller is turned on, the bait thrower can be opened with the
knob returns to the minimum. (the left knob of the GPS remote control is
the brightness adjustment knob of the headlamp, which can increase the
brightness clockwise and decrease the brightness counterclockwise.)
6 The knob on the upper right of the standard remote control is the
navigation bias adjustment knob, and the pointer of the standard remote
control knob points to the right is for the middle. When the boat is yaw to
the left, the knob can be slowly adjusted to the right, and vice versa.(the
right knob of the GPS remote control is the adjustment knob for throw
range of optional bait thrower, and the bait thrower has the open protection
program of false operation. When the remote control is in turned on, the
knob can be opened only after it is returned to the minimum.)