05 OPERATION
EN 8
Before using the hair clipper, wash, dry and comb your hair to get
perfect result.
Make sure that the appliance is charged and, if needed, install an
attachment. Set the ON/OFF button (4) to the "ON" position. Switch
the appliance off right after use. Press and hold the ON/OFF button
for approx. 3 seconds to activate/deactivate the transport lock. The
lock symbol (11) will flash for a short time and then go out.
WARNING!
• The appliance is intended for use on dry hair only.
• Do not use the appliance if you have an open wound,
cut, sunburn or blister.
Beard trimming
1. Install the precision attachment and make sure it is locked securely.
Use the adjustment wheel to set the desired length from 1 to 11 mm
(with an increment of 1 mm). Start with more length and cut the
excess off later if necessary.
2. Trim your beard. With smooth movements, move the appliance in
the direction of your hair growth, moving from the ears to the chin.
3. Trim the mustache moving the appliance from the nose to the
corners of the lips, and then to the chin.
4. At the very end, trim your neck. To do this, either take the
attachment off, or set it to a short length to make the line between
the neck and the beard as small as possible. Trim begging from the
neck up to the chin.
5. As a final touch, trim the edges of the beard.
To Next Page
Loading...