45MUAAQ: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
14
UNIT OFF
1. Set TIMER ON as previously described.
2. Set TIMER OFF as previously described. The unit starts
automatically at the set TIME ON and turns off at the set TIME OFF.
UNIT ON
1. Set TIME OFF as previously described.
2. Set TIME ON as previously described. The unit turns off
automatically at the set TIME OFF and turns on at the set TIME ON.
SLEEP Mode
The SLEEP mode is used to conserve energy and can be used when the
unit is in the COOL, HEAT or AUTO mode only.
COOL Mode
Push SLEEP. After 1 hour the set point raises by 2°F (1°C). After another
hour, the set point raises by another 2°F (1°C) and the fan runs in a low
speed. The unit shuts off 5 hours after setting the SLEEP mode. The
SLEEP mode cancels if either the MODE, TEMP, FAN, TIMER, or ON/
OFF buttons on the remote control are pressed.
HEAT Mode
Same as the COOLING mode however the set points are lowered by 2°F
(1°C).
TURBO Mode
Use the TURBO mode to cool or heat the room rapidly.
Press TURBO (an audible “beep” is heard if the indoor unit supports this
function). The fan runs on super high speed. The TURBO mode
terminates automatically 20 minutes after pressing TURBO.
The mode can be terminated immediately by pressing TURBO again.
When the TURBO mode is terminated, the unit reverts to the original
setting.
CLEAN Mode
Press CLEAN to activate or deactivate the self-cleaning function. Under
this function, the air conditioner automatically cleans and dries the
evaporator. The cleaning cycle takes 30 minutes, after which the unit
turns off automatically. Press CLEAN on the middle of the cycle to cancel
the operation and turn off the unit. This function can be activated only in
the COOL or DRY mode.
LED Light
Press LED to turn the display light on and off.
Resetting the Remote Control
If the batteries in the remote control are removed, the current settings will
be canceled and the control returns to the initial settings and enter the
STANDBY mode. Push TURBO to activate.
Time Delay
If ON/OFF is pressed too soon after a stop, the compressor will not start
for 3 to 4 minutes due to the inherent protection against frequent
compressor cycling. The unit only emits an audible beep when the signals
are received correctly.
Heating Features
If the unit is in the heating mode, there is a delay when the fan starts. The
fan starts only after the coil is warmed up to prevent cold blow.
Auto Defrost Operation
In HEATING mode, if the outdoor coil is frosted, the indoor fan and
outdoor fan turns off while the system removes the frost on the outdoor
coil. The system automatically reverts to normal operation when frost is
removed from the outdoor unit.
Auto Start
If the power fails while the unit is operating, the unit stores the operating
condition, and the unit starts the stored operation automatically when the
power is restored.
To Next Page
Loading...
