38MGRBQ: Service Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
86
7. Remove the screws of water collector, and remove the
water collector. (3 screws)
8. Remove the terminal board’s two screws and the right side
panel’s 9 screws.
9. Remove the right side panel.
2
FAN ASSEMBLY
REMOVE THE FAN ASSEMBLY
1. Remove the top cover, right side panel and front panel
from section 1, steps 1-9.
2. Remove the hex nut fixing the fan.
3. Remove the fan.
4. Loosen the 4 screws.
5. Remove the fan motor.
Right side
board
screws
Terminal
board
screws
To Next Page
Loading...
