Carrier 38NYV035M - Piping and Drain Hose Installation

– 58 –
CAUTION
• Be sure to refer to the wiring system diagram
labeled inside the front panel.
• Check local electrical regulations for any
specific wiring instructions or limitations.
10-3-5. Piping and Drain Hose Installation
Piping and drain hose forming
• Since condensation results in machine trouble,
make sure to insulate both the connecting pipes
separately.
(Use polyethylene foam as insulating material.)
Fig. 10-3-9
NOTE :
WIRE TYPE : more than 1.0mm
2
.(H07 RN-F or 60245
IEC 66).
Fig. 10-3-10
1. Die-cutting front panel slit
Cut out the slit on the left or right side of the front
panel for the left or right connection and the slit
on the bottom left or side of thefront panel for the
bottom left or right connection with a pair of
nippers.
2. Changing drain hose
For left connection, left-bottom connection and
rear-left connection’s piping, it is necessary to
relocate the drain hose and drain cap.
CAUTION
Connecting cable
about 15 cm
Terminal block
How to remove the drain cap
Clip drain cap with needle-nose pliers, and pull out.
Fig. 10-3-11
How to remove the drain hose
Die-cutting Front panel slit
Changing drain hose
Piping preparation
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Fig. 10-3-12
FILE NO. SVM-07013
Earth line
50 mm
Connecting cable
Screw
Screw
Earth line
Terminal block
Screw
Cord clamp
Terminal cover
1
2
3
1
3
2
110 mm
10 mm
10 mm
Fig. 10-3-7
Fig. 10-3-8
Fig. 10-3-6
• The drain hose can be removed by take off
screw, after that twisting and pulling.
• When removing the drain hose, be
careful of any sharp edges of steel
plate. The edges can cause injuries.
Heat insulator
Drain hose