14
Wired Remote Controller
(Available as Accessory)
5 Pin Molex plug to be
connected to Wired
Controller’s cable
Grille Display.
10 pin Molex plug to be
connected to Control Board.
Grille Louver Motor Power.
5 Pin Molex plug to be
connected to Control Board
Grille Louver Motor Power.
5 Pin Port
Grille Display
10 Pin Port
Fig. 30 --- Panel Cassette
6. Fasten the control box lid with two screws.
Fig. 31 --- Fasten the Control Box Lid
7. Close the intake grille, and close the two grille hooks.
Fig. 32 --- Close the Intake Grille
To Next Page
Loading...
