57
P2 (Low pressure protection) error diagnosis and
solution
Error Code P2
Malfunction decision conditions If the sampling voltage is not 5V, the LED displays the failure.
Supposed causes
S Wiring mistake
S Over load protector faulty
S System block
S Outdoor PCB faulty
ow
ressure protec
o
Low pressure protecon
et
er t
e w
r
ng
etween t
e
ow pressure
protector an
ma
n contro
oar
s connecte
we
o
correct
Whether the wiring
between the low pressure
protector and main control
board is connected well or
correctly
Method
Disconnect the plu
Measure the resistance o
the
low
ressure
rotecto
th
rotector is norma
t
e va
ue is
Method
: Disconnect the plug.
Measure the resistance of the
low pressure protector. If the
protector is normal the value is
o
Yes
Yes
onnect it we
Connect it well
ep
ace out
oor ma
n
oar
Replace outdoor main board
No
ep
ace
ow pressure protector
Replace low pressure protector
No
Wh
th
r th
l
w
pressure protector
i
r
k
n
Whether the low
pressure protector
is broken
Check whether the outdoo
m
ent temperature
s to
o
Check whether the outdoor
ambient temperature is too
low
No
Stop t
e uni
Stop the unit Yes
pen fu
y va
ve core o
g
pressure va
v
Open fully valve core of
high pressure valve
No
C
ec
w
et
er va
ve core
high
u
va
ve is
pene
Check whether valve core
of high pressure valve is
opened
Check i
the indoor
an runs
roper
y in coo
ing mo
Check if the indoor fan runs
properly in cooling mode
please re
er to the solution o
an
peed has been out o
control
mal
unctio
in
out t
e cause an
ave it so
ve
please refer to the solution of fan
speed has been out of control
malfunction. Find out the cause and
have it solved.
No
Yes
Yes
No
Check whether the re
rigerant
system is o
Check whether the refrigerant
system is ok
e
rigerant is not enough add the
re
rigerant
Refrigerant is not enough add the
refrigerant
No