40
DISASSEMBLY INSTRUCTIONS (CONT)
Electrical Parts (Cont)
Procedure Illustration
5) Disconnect the wires. Then remove the
electronic main box (CJ_OP_INV_011-
2).
6) Pull out the Electrical control box along
the direction indicated in the image.
to remove it (CJ_OP_INV_011-2).
7) The connector of each port is indicated
in right image. (CJ_OP_INV_013).
CJ_OP_INV_012
CJ_OP_INV_013
Main Board
Electronic Box
Swing Motor
Pipe Temperature Sensor
Display Board
Indoor Fan Motor
Terminals
Ground Wire
To Next Page
Loading...
