Carrier 40UV - Page 35

(SEE NOTE
NOTES:
I. Not allcomponents shown forclarity,
2. Items no. 7, 10 and associated hardware not required for
40UV,UH150. Refer to Fig. 11 for 4guv, uH150 in-board bearing
replacement. (_
3, Install motorwith e;ectrical connections facing front of assembly.
4, Install oilcup facing up and towards the rear of the assembly. LEFTSIDE
VIEW
Fig. 15 -- 40UV,UH Ventilator Blower Drive Train Assembly --
40UV050-150 and 40UH075-150 Units (ECM Motor)
UNIT FRONT (40UV)
UNIT BOTTOM (40UH)
35