Carrier 42PHQ P Series - Advanced Remote Control Features; Timer Cancellation, Sleep Timer, and Time Adjustment; Reset Function and Ionizer Operation

GB - 9
42PHQ...P
R-410A
ENGLISH
Cancellation of ON, OFF and DAILY timer
procedure
1. If you want to cancel On or OFF timer
setting, press the following buttons in
sequence:
• button or ;
• button
.
To deactivate the Everyday function, press
button
. The Everyday function will remain
operative until one of the two timers (ON or
OFF) is active.
Sleep timer procedure “night” (button M)
Press this button to set the SLEEP timer with remote control on.
The icon will appear on the display.
This procedure permits setting the remaining unit operating time.
1. “1:hr” will be displayed together with the
icon.
2. Press button (temperature increase).
The display will show the following settings
in sequence:
1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr, 8hr and 9 hr.
3. Once the remaining operating hours have
been selected with either button
or ,
again press button
to confirm.
4. When the SLEEP timer is set, the unit will
control the set temperature to avoid
overcooling or overheating during operation.
The set temperature will change as follows:
Use of the remote controller
Current time adjusting and reset buttons
(buttons K and O)
Press current time adjusting button for more than 5 seconds to
adjust the current time.
Press reset button “O” with a sharp object if the remote control is
not operating properly or after replacing the batteries.
Setting current time (button K)
1. With the remote control On or OFF,
press button . for more than
5 seconds
2. The current hour figure flashes.
Press either button
or
to set the current hour.
Press button to move to
minutes and set them.
3. For this setting always use
either button
or .
4. Once the current time is set,
press button
.to confirm it.
Ionizer function button (button N)
1. Press Ionizer button to activate
Ionizer function during unit ON.
2. Press Ionizer button again to stop
Ionizer function.
Address selector
If you have two indoor units in the same room, you can link one
remote controller to one indoor unit, and the other remote controller
to the other indoor unit, or you can control both indoor units with a
single remote controller.
For configuration, refer to the installation manual.
PM
(Heating)
(Cooling only or dehumidification)
PM
A
B
1
2
-1°C
°C
30 90 150
-1°C
-1°C
SET
TEMP.
SET TIME
TIME (MIN.)
+0.5°C
+0.5°C
+0.5°C
+0.5°C
°C
30 70 110 150
SET TIME
TIME (MIN.)
SET
TEMP.