GB - 8
42PHQ...P
R-410A
About the ON timer
• When the ON Timer function is operating,
the unit senses the room air temperature
1 hour before the start-up time.
• The unit start can be brought forward based
on the programmed start time, by 0 to 40
minutes, depending on the temperature
difference between the room and the
selected temperature.
OFF timer procedure
1.OFF TIMER button (button L)
Press button .
The OFF timer icon and numbers for time
selection are flashing.
This function can be set even if the remote
control is OFF.
2. HOUR/MINUTE selection buttons
(buttons
and )
To set the clock time, press either button or .
To move from hour to minute, press button .
Press button again to confirm.
Personalisation and (buttons G and F)
If you want memorize a personalised operating mode, recallable at
any time, proceed as follows:
1. With the remote control ON or OFF, select the desired operating
mode, temperature, fan speed and louver.
2. Press button
for more than 5 seconds.
At this point, all selected and memorised functions can be activated
through button
, whatever the unit operating mode. Once the
personalised mode has been entered, press one of the buttons
, , , to exit.
If you want to change one or more
memorised parametres, begin again from point 1.
DAILY timer (Everyday - button J)
Push the button when the ON or OFF timer is active. The icon
will appear on display. In this way the ON and OFF timer
memorization will be repeated every day. To disactivate the daily
function, press again the button
.
Combination of ON, OFF and DAILY timer
procedure
If you want operation to start at 5.30 P.M. and stop at 10.30 P.M.,
proceed as follows:
1. Select ON timer at 5:30 P.M.
2. Select OFF timer at 10:30 P.M.
3. Select the desired operating mode (button ).
If you want to stop operation at 10:30 P.M. and start again at
7:30 A.M. with the same operating mode, proceed as follows:
1. Select OFF timer at 10:30 P.M. during operation
2. Select ON timer at 7:30 A.M.
If you want Everyday operation to start at 5.30 P.M. and stop at
10.30 P.M., proceed as follows:
1. Select ON timer at 5:30 P.M.
2. Select OFF timer at 10:30 P.M.
3. Press the Everyday button (daily button ).
Use of the remote controller
4. Operating mode
Choose the unit operating mode.
The icons will flash.
To select the mode, use the button
.
Once the mode has been decided, press
button
. The icon of the selected mode
will stop flashing.
5. Desired temperature
To select the desired temperature, (the
value is flashing, use either button
or .
Push button
, to confirm the selection.
Numbers will stop flashing.
6. Fan speed
Choose the fan speed, using button
.
When the selection has been completed,
press button
for confirmation.
The icon will stop flashing.
7. Louvre positioning
Now this icon is flashing.
Use button
, to select desired position.
Press button
for confirmation.
Now all icons are fixed on display.
If you want to cancel selections up to
here inserted, push button
; if you want
to cancel all options once timer has been
set, push button
and then .
PM
PM
PM
AM
PM
PM
PM
To Next Page
Loading...
Need help?
General
