GB - 7
42PHQ...P
R-410A
ENGLISH
Start / Stop
(button B)
When the air conditioner is not in operation, the remote control
readout will display the time of day only (in case other symbols are
lit, turn control off by pressing button
).
Press button
to start the air conditioner.
All selected and memorized functions will light up and appear; the
unit will operate according to the functions selected.
Press button
to stop the air conditioner.
All indicators on the unit will go out, and the control will display
only the current time.
If the unit does not stop, turn the control on (by pressing button
) and repeat the operation.
If button
(air conditioner starting) is pressed too soon after a
stop, the compressor will not start for 3/5 minutes due to the
inherent protection against frequent compressor cycling.
The unit will only emit a “beep”, when the signals are received correctly.
Selection of the operating mode
(button A)
With this button the operating mode of the air conditioner can be
selected. By repeatedly pressing this button the available modes
will be selected in sequence.
The choosen mode is shown as follows, while the unit will
acknowledge signal receipt with a confirming beep.
Indicated Symbol
Ventilation (fan only).
Heating.
Automatic.
Cooling with dehumidification.
Dehumidification only.
Temperature setting
UP
(button C)
DOWN
(button D)
Pressing the UP and DOWN buttons will increase or
decrease the temperature from the previously set value. The unit
will confirm signal receipt with a beep, and the value of the set
temperature on the display will change accordingly.
The temperature can be set between 17°C (63°F) and 32°C (90°F)
at 1 degree intervals.
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for the
heating mode, if the selected temperature is lower than the room
temperature.
Selecting direction of air flow louvre
(button H)
The air flow direction can be adjusted to optimize air distribution in
the room.
Press button
repeatedly to choose one of the following louvre
positions:
Symbol on display
Air direction will be set automatically.
Louvre will be set to the preset position according to the
operation mode.
Use of the remote controller
6 positions can be chosen.
The louvre can be set to one of 6 different air
flow directions.
The louvre will continuously swing up and down. "Swing"
always assures optimal even air distribution in the room.
In the COOL DRY and FAN mode, the louvre will swing in the cooling
range.
In the HEAT mode, the louvre will swing in the heating range.
Selecting the fan speed
(button E)
The fan speed can be selected by pressing button .
Indicated symbol
Low speed
(for night operation)
Medium speed
High speed
(at start-up, to reach temperature)
Automatic (fan speed will automatically switch to the value
required for optimum comfort).
ON timer procedure
1
.
ON TIMER button (button I)
Press this button, even if the remote
control is OFF. The relevant icon and time
figure will startto flash.
If 10 seconds have elapsed and no
button is pressed, the remote control
turns OFF (if it was already OFF when
button
was pressed) or timer function
automatically deactivates.
2.HOUR/MINUTE buttons
(buttons
and )
If the unit is ON, the only possible
selection is the start-up time.
The unit will operate with the selections
shown on the display.
3.HOUR/MINUTE buttons
(buttons
and )
If the unit is OFF: to select the start-up
time, use the temperature control buttons
(buttons
and ). First select the hours
and, after have confirmed these by
pressing button
, select the minutes
using either button
or .
To definitively set the time, press button
again.
Cooling
Heating