Carrier 42TVEA013 - Unit Operation and Control; Remote Control Overview

3
INDOOR UNIT DISPLAY
1
● Display brightness can be adjusted, follow procedure on ".
1
ECO (White)
2
Wi-Fi access (White)
3
Hi Power (White)
4
Timer (White)
5
Operation Mode (White)
Preparing Filters
1. Open the air inlet grille and remove the air lters.
2. Attach the lters. (see detail in the Installation Manual).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
1. Push by tip of the pencil.
If timer indication is ashing, go to the next step 2.
2. Press or : adjust the time.
3. Press : Set the time.
Remote Control Reset
Push
by tip of the pencil or
1. Remove the batteries.
2. Press
3. Insert the batteries.
PREPARATION BEFORE USE
2
AIR FLOW DIRECTION
3
1
Press : Move the
louver in the desired vertical
direction.
2
Press : Swing the air
automatically and press again
to stop.
3
For horizontal direction, adjust
manually.
Note:
●
Do not move the louver manually by hands or others.
●
The louver may automation positioning by some operation mode.
REMOTE CONTROL
4
1
Infrared signal emitter
2
Start/Stop button (
)
3
Mode select button (
)
4
Temperature button (
)
5
Fan speed button (
)
6
Swing louver button (
)
7
Set louver button (
)
8
On timer button (
)
9
Off timer button (
)
!
Set louver button (
)
"
Set louver button (
)
#
Memory and Preset button (
)
$
High power button (
)
%
Economy button (
)
&
Quiet button (
)
(
Comfort sleep button (
)
) Filter reset button (
FILTER
)
~
Set clock button (
CLOCK
)
+
Check button (
CHECK
)
,
Reset button (
RESET
)
1
2
12
3
7
15
8
16
19
18 17
20
10
11
9
13
5
6
4
14
Note:
 ● The provided Remote Controller is a wireless type, which also can be
used as a wire. Please see “How to Connect The Remote Controller
for Wired Operation”, located in installation instruction, in case of wired
control is required.
 ● In wire operation, remote controller will return to initial condition
(PRESET, TIMER and CLOCK will return to initial condition) when user
shutdown power supply of Air conditioner.
AUTOMATIC OPERATION
5
To automatically select cooling operation
1. Press : Select Auto A.
2. Press : Set the desired temperature. Min. 17°C, Max. 30°C.
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+
, HIGH .
COOLING OPERATION
6
1. Press : Select Cool .
2. Press : Set the desired temperature. Min = 17°C, Max = 30°C.
3. Press : Select AUTO, LOW , LOW+ , MED ,
MED+
, HIGH
DRY OPERATION
7
For dehumidication, a moderate cooling performance is controlled
automatically.
1. Press : Select Dry .
2. Press : Set the desired temperature. Min. 17°C, Max. 30°C.
Note: DRY mode fan speed is set to Auto only.
Book_OM_1144180223_EN_TH.indb 3Book_OM_1144180223_EN_TH.indb 3 23/12/2565 BE 09:2723/12/2565 BE 09:27