18
Display the selected functions
1. Disconnected
2. Selected temperature/ambient
temperature
3. Set temperature
4. Deflector operating position
5. Fan speed
6. Cooling
7. Dehumidification only
Control Powered Up
All of the segments of the Remote Control
Display must be powered up for five
seconds. Information about the operating
mode, fan speed, desired temperature and
configuration must be read from the
Microprocessor inside the Remote Control.
If the EEPROM values are not valid, the
following must be used by default.
Example of normal operation
When connected, the control display
appears.
Operating Mode = AUTO
Fan Speed = AUTO
Desired Temperature = 22
o
C
o
F or
o
C=C
Deflector (louver) = AUTO
Cancellation of the Ambient Thermistor = OFF
Cooling Only = Cool
To Next Page
Loading...
