Carrier 48TC - Step 13 - Adjust Factory- -Installed Options; Step 14 - Install Accessories

19
C08019
Fig. 25 -- EconoMi$er IV Wiring
Step 13 — Adjust Factory--Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Controls
Connect ions Board, at termi nals marked “Smoke
Shutdown”. Remove j umper JMP 3 when ready to
energize unit.
EconoMi$er IV Occupancy Switch —
Refer to Fig. 25 for general EconoMi$er IV wiring.
External occupanc y control is managed through a
connec tion on the Controls Connections Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied seque nce) at terminals marked
OCCUPANCY. Remove or cut jumper JMP 2 to c omplete
the installation.
Step 14 — Install Accessories
Available accessories include:
Curb
Thru--base connection kit (must be installed before unit
is set on curb)
LP conversion kit
Manual outside air damper
Two-- Position motorized outside air damper
EconoMi$er IV (with control)
EconoMi$e r2 (without control/for external signal)
Barometric relief
Power Exhaust
Differential dry--bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
CO2 se nsor
Smoke detector (Return Air and/or Supply Air)
DDC interface (PremierLink)
4--Inch filter tracks
Louvere d hail guard
Hood--type hail guard
UV--C lamp kit
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
48TC