Need help?Do you have a question about the Carrier 50DD016 and is the answer not in the manual?
General| Brand | Carrier |
|---|---|
| Model | 50DD016 |
| Category | Accessories |
| Language | English |
Proper unit placement, lifting, and leveling are crucial for safe installation.
Instructions for installing the roof curb for proper unit drainage and sealing.
Guidelines for preparing a level concrete slab for unit installation.
Advice on unit placement for airflow, safety, and service access.
Details on connecting ductwork to the unit, including concentric and side connections.
Specific duct connection limitations for units with an economizer.
Options for connecting ductwork to units with manual dampers.
Information for side duct connections on larger units.
Step-by-step procedure for converting units for side duct connections.
Wiring for thermostats and control panels in constant volume systems.
Control wiring details for units without room thermostats.
Installation and wiring of outdoor air thermostats for electric heat staging.
Initial steps for starting cooling operation on constant volume units.
Procedures for safely shutting down the unit.
Setting outdoor air thermostat for fresh air cooling.
Cooling stage control for 50DD012 and 016 units.
Cooling stage control for 50DD024 units.
Cooling stage control for larger units.
Adjusting the temperature setting on the proportional thermostat.
Adjusting the range of the proportional thermostat.
Setting and adjusting step controller switches for unit operation.
Instructions for cleaning unit interior, coils, drains, and filters.
Maintenance procedures for condensate drains.
Guidelines for cleaning or replacing return air filters.
Steps to adjust indoor fan speed by altering pulley settings.
Steps for removing fan pulleys from the motor shaft.
Procedure for aligning fan pulleys to ensure proper operation.
Methods for adjusting belt tension on indoor fan motors.
Damper adjustment for economizer on specific models.
Damper adjustment for economizer on larger models.
Standard evacuation procedures before charging.
Procedure for adding refrigerant to correct low charge.
Standard evacuation procedures before charging.
Standard evacuation procedures before charging.
Procedure for adding refrigerant using sight glass.
To Next Page
