93
APPENDIX A: SystemVut Controller Display
Service Main Menu L ayout (cont)
Display Text Expanded Text Values Units Write Status Point
HARDWARE INPUTS (cont) Hardware inputs menu
RELAY 06 FUNCTION Assigned Rly 06 Function 0=None,
1=ALM Relay,
2=PE1,
3=PE2
MBBRY06F
RELAY 11 FUNCTION Assigned Rly 11 Function 0=None,
1=ALM Relay,
2=PE1,
3=PE2
MBBRY11F
MBB PART # MBB Part Number CEPL131117--- xx--- R BD_CEPL
MBB PP MBB Progra m Part Number CEPP130644--- xx--- xx--- xx--- R BD_CEPP
MBB SERIAL # Base Board serial number xxxxNxxxxxx BD_SER
CALIBRATION Calibration Menu
OATTRIMOFFSET OAT Sensor Trim Offset --- 10.0 to 10.0 °F Configurable OAT_TRIM
RAT TRIM OFF SET RAT Sensor Trim Offset --- 30.0 to 30.0 °F Configurable RAT_TRIM
FST TRIM OFFSET FST Sensor Trim Offset --- 10.0 to 10.0 °F Configurable FST_TRIM
SPTTRIMOFFSET SPT Sensor Trim Offset --- 30.0 to 30.0 °F Configurable SPT_TRIM
SLIDER SEN. TRIM SPTO Sensor Offset Trim --- 1 . 0 t o 1 . 0 °F Configurable SPTOTRIM
SPRH TRIM OFFSET SPRH Sensor Offset Trim --- 15 t o 15 % Configurable SPRHTRIM
IAQ TRIM OFFSET IAQ sensor trim offset --- 200 to 200 ppm Configurable IAQ_TRIM
OAQ TRIM OFFSET OAQ Sensor Trim Offset --- 200 to 200 ppm Configurable OAQ_TRIM
OARH TRIM OFFSET OARH Sensor Trim Offset --- 15 to 15 % Configurable OARHTRIM
RARH TRIM OFFSET RARH Sensor Trim Offset --- 15 to 15 % Configurable RARHTRIM
CIR.A SSP TRIM Cir.A SSP Sensor T rim --- 50 to 50 psig Configurable SSPATRIM
CIR.A SDP TRIM Cir. A SDP Sensor Trim --- 50 to 50 psig Configurable SDPATRIM
ECO FEEDBACK TRIM Econ Fdback Trim Offset --- 15 to 15 % Configurable EC1DTRIM
OACFMTRIMOFFSET OACFM sensor trim offset --- 10 t o 10 CFM Configurable OCFMTRIM
COMMISSION REPORTS Commission Report Menu
SYSTEM STARTUP CHECKLIST SYSTEM STARTUP CHECKLIST MENU
QUICK SET CHKLIST QUICK SETUP CHECKLIST 0=Undone,
1=Perfom,
2=Done
Configurable CHK_QUIK
NETWORK CHKLIST NETWORK SETUP CHECKLIST 0=Undone,
1=Perfom,
2=Done
Configurable CHK_NET
SYSTEM AUTOTEST CheckList Auto test 0=Undone,
1=Perfom,
2=Done
Configurable CHK_ATS T
ADVANCED SERVICE Advanced Service Restricted Access Menu
RESTORE DEFAULTS? Restore Factory Defaults Yes/No Command RESFDFLT
CLEAR COMPONENT DATA RESET COMPONENT DATA MENU
COMP A1 DA TA Reset Compressor A1 Data Ye s/No Command CR_A1
COMP A2 DA TA Reset Compressor A2 Data Ye s/No Command CR_A2
ALARM RELAY DATA Reset Alarm Relay Data Ye s/No Command CR_ALM
ALARM RESET DATA Re set Alarm Resets Data Yes/No Command CR_ALRST
CCH RELAY DAT A Reset CCH1 Relay Data Ye s/No Command CR_CCHR1
ECON DAMPER DATA Reset Econ Damper Data Yes/No Command CR_DAMP
FULL LOAD DATA Reset Full Load Data Yes/No Command CR_FLOAD
FREE COOL DATA Reset Free Cooling Data Yes/No Command CR_FREEC
HEAT 1 DATA ResetHeatStage1Data Yes/No Command CR_HTR_1
HEAT 2 DATA ResetHeatStage2Data Yes/No Command CR_HTR_2
IDF RUN DATA Reset Indoor Fan Data Yes/No Command CR_IDF
IDF MAX SPD DATA Reset Max Fan Speed Data Yes/No Command CR_MAXF
ODF1 OUTPUT DATA Reset ODF Spd Sig 1 Dat a Yes/No Command CR_ODF1
ODF2 OUTPUT DATA Reset ODF Spd Sig 2 Dat a Yes/No Command CR_ODF2
ODF3 OUTPUT DATA Reset ODF Spd Sig 3 Dat a Yes/No Command CR_ODF3
PE1 RELAY DATA Reset Pwr Exhaust 1 Data Yes/No Command CR_PE_1
PE2 RELAY DATA Reset Pwr Exhaust 2 Data Yes/No Command CR_PE_2
POWER RESET DATA Reset Power Resets Data Yes/No Command CR_POR
TEST MODE DATA Reset Service Test Data Yes/No Command CR_STEST
VENT IDF DAT A ResetVentIDFData Yes/No Command CR_VENTF
INPUTS Inputs Menu
TEMPERAT URES Temperatures Menu
SUPPLY AIR TEMP Supply Air Temperature xxx..x °F SAT
OUTDOOR AIR TEMP Outdoor Air Temperature xxx.x °F Forcible OAT
RETURN AIR TEMP Return Air Temperature xxx.x °F Forcible RAT
SPACE TEMPERATURE Space Temperature xxx.x °F Forcible SPACE_T
SLIDER OFFSET VAL Space Temperature Offset xx.x °F Forcible SPTO
CIR.A SUC TEMP Cir . A Sat.Suction Temp xxx.x °F SST_A
To Next Page
Loading...
