To Next PageTo Next Page
Need help?Do you have a question about the Carrier 59TN6B and is the answer not in the manual?
Details specific installation rules required by Massachusetts regulations for gas fueled equipment.
Outlines manufacturer requirements for gas equipment venting systems, including provided or not provided parts.
Covers warnings for fire, explosion, electrical shock, and carbon monoxide poisoning during operation and service.
Addresses hazards related to furnace reliability and potential cut injuries from sheet metal parts.
Specifies hazards and general requirements for furnace installation locations, including construction heat.
Lists national and local codes for safety, installation, combustion air, and duct systems.
Details precautions to protect furnace electronic controls from electrostatic discharge during installation and servicing.
Addresses combustion air contamination hazards and installation site restrictions like garages.
Explains requirements for direct-vent, non-direct-vent, and ventilated air systems, including outdoor air methods.
Covers condensate trap positioning for different orientations and installation notices.
Details precautions for freezing and property damage, and routing for right and left side drains.
Provides installation notices and guidelines for upflow supply air connections.
Covers return air inlet types, leveling legs, and downflow installation.
Details platform/suspended support, roll-out protection, and supply/return air interfaces.
Addresses filter hazards, arrangement, and sizing for return duct systems.
Covers duct system design, general requirements, return duct sizing, and acoustical treatment.
Details gas piping hazards, installation codes, and the use of gas pipe grommets.
Covers electrical hazards, 115-V wiring, and installation standards for US and Canada.
Details J-Box installation and external electrical box mounting and wiring.
Covers wiring for power cords, BX cables, 24-V systems, thermostats, and accessories.
Outlines special Canadian venting requirements and carbon monoxide hazards.
Describes direct-vent, ventilated, and non-direct vent systems and termination location rules.
Provides information on polypropylene venting systems and insulation guidelines.
Details installation of vent and combustion air pipes near the furnace, including hazard warnings.
Covers roof, concentric, and 2-pipe/single-pipe termination types and requirements.
Outlines start-up procedures, safety checks, and setup switch configurations for furnace operation.
Details condensate trap priming and checking essential safety controls for furnace operation.
Covers furnace hazards, gas valve adjustments, and orifice checks for proper operation.
Explains how to check inlet gas pressure to ensure proper furnace operation.
Covers temperature rise adjustments for heat modes and blower off-delay settings.
Details continuous fan airflow selection and heat anticipator adjustment procedures.
Provides general warnings and procedures for cleaning heat exchangers and other components.
Covers electrical controls, wiring diagrams, status codes, and component self-test procedures.
Details procedures for cleaning or replacing air filters and maintaining blower motors.
Covers igniter resistance checks, replacement, and condensate drain system flushing.
Provides winterization procedures and explains the furnace sequence of operation.
Lists furnace parts by group and provides model nomenclature for identification.
General
