EasyManua.ls Logo

Carrier AquaEdge 23XRV - Page 166

Carrier AquaEdge 23XRV
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CL-2
-
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - -
CUT ALONG DOTTED LINE CUT ALONG DOTTED LINE
RECORD PRESSURE DROPS: Cooler Condenser
CHARGE REFRIGERANT: Initial Charge Final Charge After Trim
INSPECT WIRING AND RECORD ELECTRICAL DATA:
Verify 6 clearance surrounding all Control Center louvers Yes
No
Visually inspect down through top of power module for debris Yes No
RATINGS:
Motor Voltage
Motor(s) Amps Oil Pump Voltage Starter LRA Rating
Line Voltages: Motor Oil Pump Controls/Oil Heater
RECORD THE FOLLOWING POWER ON CHECKS:
What type and size of transformer supplies power to the unit?
Delta with No Ground _____
Corner Grounded Delta _____
Wye with Center Ground _____
Wye with No Ground _____
Transformer Size _____kVa
FIELD-DISASSEMBLED CHILLERS ONLY:
Megger Test Motor if the VFD is removed from the chiller.
Check continuity T1 to T1, etc. (Motor to starter, disconnect motor leads T1, T2, T3.) Do not megger VFD;
disconnect leads to motor and megger the leads.
CONTROLS: SAFETY, OPERATING, ETC.
Verify parameters in VFD_conf screen. Yes
No
Perform Controls Test Yes No
CHECK OIL LEVEL AND RECORD: ADD OIL: Yes No
Amount:
1/2 Oil sump sight glass
1/2 Strainer housing sight glass
3/4
1/4
3/4
1/4
Line Voltage: Phase - Phase A-B: B-C: A-C:
Line Voltage: Phase - Ground A-G: B-G: C-G:
MEGGER MOTOR
“PHASE TO PHASE” “PHASE TO GROUND”
T1-T2 T1-T3 T2-T3 T1-G T2-G T3-G
10-Second Readings:
60-Second Readings:
Polarization Ratio:
PIC III CAUTION
COMPRESSOR MOTOR AND CONTROL CENTER MUST BE PROPERLY AND INDIVIDUALLY
CONNECTED BACK TO THE EARTH GROUND IN THE STARTER (IN ACCORDANCE WITH
CERTIFIED DRAWINGS).
Yes
Water/Brine Pump Control
Can the Carrier controls independently start the pumps?
Condenser Liquid Pump Yes No
Chilled Liquid Pump Yes No

Table of Contents

Other manuals for Carrier AquaEdge 23XRV

Related product manuals