Need help?Do you have a question about the Carrier AquaSnap Plus 30AWH004HB and is the answer not in the manual?
General| Model | 30AWH004HB |
|---|---|
| Type | Air-to-water heat pump |
| Heating Capacity | 45 kW |
| Efficiency Rating | A++ |
| Compressor Type | Scroll |
| Voltage | 400V |
| Phase | 3 |
| Power Supply | 400V/3Ph/50Hz |
| Refrigerant | R410A |
Guidelines for selecting the optimal location for the outdoor unit.
Procedures and recommendations for connecting the unit to the water system.
Instructions for making safe and proper electrical connections to the unit.
Details on optional control wiring and main power supply connections.
Steps for filling the water circuit and flushing to remove air and impurities.
Methods for checking water leaks and final system setup and operational checks.
Explanation of symbols, marks, and danger/warning indicators used in the manual.
Important general guidelines, safety precautions, and manufacturer liability information.
Safe practices and precautions for handling the unit during installation and maintenance.
Criteria for selecting suitable installation sites, avoiding specific adverse conditions.
Critical safety warnings and procedures for electrical connections by qualified personnel.
Specifies required clearances around the unit and lists physical dimensions for different models.
Provides key performance specifications, capacity, and operating parameters of the unit.
Guides for opening cable knockouts and removing the front panel for access.
Procedures for drain management and defines operational temperature ranges for cooling/heating.
Details on integrated hydronic module components and hydraulic connection requirements.
Guidelines for water circuit setup and anti-seizing pump protection.
Procedures for cleaning the water circuit and maintaining water quality standards.
Table detailing water content per meter for various pipe sizes and materials.
Illustrates typical water circuit diagrams for 30AWH_X and 30AWH_H units.
Provides detailed electrical specifications, power requirements, and recommended cable types.
Information on connecting wired remote controllers and various auxiliary components.
Instructions for connecting the 3-way valve and limiting unit frequency for noise reduction.
Explanation of status signals and connecting an external temperature probe.
Instructions for connecting and configuring dehumidifier or humidifier functions.
Details on managing an additional water pump and configuring external heat source requests.
Information on driving an external circulator and using the external alarm input for safety.
Detailed table mapping accessory descriptions to terminal pins and menu codes for 30AWH_H.
Detailed table mapping accessory descriptions to terminal pins and menu codes for 30AWH_X.
Identifies alarm codes indicated by LEDs on the inverter board for 30AWH012_ models.
Guide to interpreting LED indicators on the cycle control P.C. board for diagnostics.
Identifies alarm codes indicated by LEDs on the inverter board for 30AWH015_ models.
Details on switching between display modes and interpreting error contents via DIP switches.
Lists fault codes and their descriptions for errors detected by the GMC board, including LED flashing patterns.
Table detailing safety devices like pressure switches and anti-freeze protection with their parameters.
Step-by-step instructions for cleaning the unit's heat exchanger coil safely and effectively.
Guidelines for correctly charging refrigerant after leaks or compressor replacement, emphasizing liquid charging.
To Next Page