Carrier DHMSHAQ09XA1 - Page 39

39
DISASSEMBLY INSTRUCTIONS (CONT)
2 Electrical
parts
How to remove the
electrical parts.
1) After removing the
front panel (see
section 1), pull out the
room temperature
sensor and
evaporator coil
sensor. Remove the
grounding screws.
2) Pull out the clip toward
the left side and open
the cover.
3) Remove the securing
screw and open the
box cover.
4) Pull out the connectors
of the swing motor
and the fan motor.
5) Remove the securing
screw and remove
the electronic control
box and air outlet
assembly.
Fixing screw
Swing motor
Fan motor connector
and swing motor
Clip for electronic
control box cover
Grounding screws
Evaporator coil
temp. sensor
Room temp.
sensor