Carrier DHMVHAQ24XA3 - Electrical Parts Disassembly

:
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
47
DISASSEMBLY INSTRUCTIONS (CONT.)
Electrical Parts
Procedure Illustration
1) Remove the screw and then remove
the electronic box cover and the
terminal cover.
2) Pull out the room temperature sensor
(T1) and the coil temperature sensor
(T2.
3) Remove the two screws used for the
ground connection.
T1 Sensor
Ground Screws
T2 Sensor
Screw
Electronic Cover