Carrier DLFEHA - Advanced Remote Functions; Swing, Shortcut, Turbo, and Clean

DLFEHA: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
12
How to Use Advanced Functions
Swing Function
Shortcut Function
Press Swing
Press Shortcut
The horizontal louver swings up and down
automatically when pressing
Swing.
Press
Swing again to make it stop.
Keep pressing Swing more than 2 seconds,
the vertical louver swing function activates.
(model dependent)
2s
Swing
Turbo Function
Press Turbo
Turbo
Swing
Swing
Push Shortcut when the remote control is on, the system automatically
reverts back to the previous settings including the operating mode, setting
temperature, fan speed level and sleep feature (if activated).
If pushing more than 2 seconds, the system automatically restores the
current operation settings including operating mode, setting temperature,
fan speed level and sleep feature (if activated).
Select Turbo in the COOL mode and the unit blows cool air with the strongest
wind setting to jump-start the cooling process.
Select the Turbo feature in the HEAT mode, for units with Electric Heat
elements, the Electric Heater activates and jump-starts the heating process.
Clean Function
Press Clean
Airborne bacteria can grow in the moisture that condenses around the heat exchanger
in the unit. With regular use, most of this moisture is evaporated from the unit.
By pressing Clean, the unit cleans itself automatically. After cleaning, the unit
turns off automatically. Press Clean in mid-cycle to cancel the operation and turn off
the unit. Use Clean as often as you like.
Note: You can only activate this function in the COOL or DRY mode.
Clean