SMART SENSOR OPERATION
The Infinity Smart Sensor allows control and changing of zone temperature setpoints. Continuous FAN selection is available; AUTO, LOW,
MED, HIGH. Other features include viewing Outdoor Temperature and Indoor Relative Humidity. Infinity Smart Sensor Functions also
include; HOLD and UNOCCUPIED settings.
Outside Temp /
Indoor Humidity
Hold/Unoccupied
Time (+/-)
Temp (+/-)
COOL / HEAT
Set point
Room Temperature
Fan Control
Fan Status
Humidity/OAT
HOLD
A04136
CHANGING DESIRED TEMPERATURE
• The current zone temperature will be displayed in the LCD.
• Press COOL/HEAT button to change between ″COOL AT″ and ″HEAT AT″ setpoints.
• Press Temp (+/-) button to raise or lower setpoints.
• The default time for temporarily overriding the temperature schedule is 2:00 HRS as indicated by the
text in the lower left screen.
• Temporary override time can be changed in 15-minute increments by pressing the TIME (+/-) button
to increase or decrease the override timer.
NOTE: Override will not appear if programming has been turned off.
HOLD/UNOCCUPIED
• Pressing HOLD / UNOCCUPIED button will display HOLD allowing setpoints to remain permanent
and override any existing program schedules. Pressing HOLD/UNOCCUPIED button again will release
HOLD and return to previous program schedules.
• Pressing HOLD/UNOCCUPIED button for approximately 3 seconds will display UNOCCUPIED
status on lower left screen. Pressing button again for approximately 3 seconds will release
UNOCCUPIED status and return to previous mode.
CONTINUOUS FAN ADJUSTMENT
• Pressing the FAN button will scroll through the following: AUTO, LOW, MED, HIGH.
• When AUTO is selected, zone airflow is available only when a heating or cooling demand exists within
the zone.
• When LOW, MED, or HIGH is selected, zone airflow will be continuous without a heating or cooling
demand.
OUTDOOR TEMPERATURE AND INDOOR RELATIVE HUMIDITY
• The current outside temperature is displayed in upper left corner of the LCD.
• Press and release the HUMIDITY/OAT button to view % Indoor Relative Humidity, value is measured
at Zone Control (User Interface).
• Outdoor temperature will return after five seconds, or after the button is pressed again.
A04141
A04142
OVERRIDE
2:00 HRS
A04143
UNOCCUPIEDHOLD
A04141
A04144
%RH INSIDE 50
5
To Next Page
Loading...
