14
NOTE: To keep water from entering the wired remote controller, use a trap and putty to seal the wired
connectors during the wiring installation. During installation, reserve a certain length of the connecting
wire to make removing the wired remote controller easier during maintenance.
9. Re−attach the upper part of the wired controller.
10. After adjusting the upper case, buckle the upper case. Avoid clamping the wiring during
installation.
NOTE: The pictures in this manual are for illustration purposes only. Your wired controller may differ
slightly.
Copyright 2016 CAC/BDP. S 7310 W. Morris St. S Indianapolis, IN 46231 Edition Date: 01/16
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Replaces:KSACN0101-01SI
Catalog No: KSACN0101-02SI
To Previous Page
Loading...
