IM-KSAIC03-02 Specifications subject to change without notice. 13
WIRING DIAGRAM
Fig. 21 —Wiring Diagram
GLOSSARY:
• Remote Control (CN14): This is a dry contact to control the indoor unit on and off remotely.
• Alarm Output (CN7): This is a dry contact that opens and closes based on the alarm status of the system. This is a normally
closed Dry contact.
• Work Output (CN6): This contact is a dry contact that open and closes based on the system running or not running
condition.When the compressor is active this contact closes.
FAN OUTPUTS:
• (G1) Low Fan Speed
• (G1 + G2) Medium Fan Speed
• (G1+ G2 + G3) High Fan Speed
For single fan speed only, G1 has to be connected.
ON ON
NOTE: If the SW4-1 is ON, the SW4-2 takes
effect, otherwise the SW1-2 takes effect.
Dry Mode
Fan Low/Medium/High
To Next Page
Loading...
