Carrier NP034-074 - Page 11

UNIT SIZE
WEIGHT A B C D E F G H J
lb kg mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in.
48DJD,DKD,NPD
034
5641 2559 4498 14-9
1
⁄ 8
3662 12-0
3
⁄ 16 7278 23-10
9
⁄ 16 1709 5-7
5
⁄ 16 2216 7- 3
1
⁄ 4 4228 13-10
7
⁄ 16 2746 9-0
1
⁄ 8 — — 3626 12-10
9
⁄ 16 48DJE,NPE 5770 2617 4474 14-8
1
⁄ 8
50DW,DY,NB 5970 2708 4044 13-3
1
⁄ 4
48DJD,DKD,NPD
044
6541 2967 5255 17-2
7
⁄ 8
4497 14-9
1
⁄ 16 8496 27-10
1
⁄ 2 2328 7-7
5
⁄ 8 2091 6-10
5
⁄ 16 4706 15-5 3363 11-0
3
⁄ 8 3769 12-4
3
⁄ 8 4762 15-7
1
⁄ 2 48DJE,NPE 6670 2708 5229 17-1
7
⁄ 8
50DW,DY,NB 6620 3003 4823 15-9
7
⁄ 8
UNIT SIZE
KL
mm ft-in. mm ft-in.
48DJD,DKD,NPD
034 4741 15-6 6797 22-3
5
⁄ 8 48DJE,NPE
50DW,DY,NB
48DJD,DKD,NPD
044 5576 8-3
1
⁄ 2 8015 26-3
9
⁄ 16 48DJE,NPE
50DW,DY,NB
LEGEND
CONN — Connection
DIM — Dimension
NOTES:
1. Dimensions in [ ] are in millimeters.
2. Centerof Gravity includes economizer. Unit weight does
not include economizer.
3. Unit clearances:
Top — Do not restrict condenser fans
Control Box End — 68-09
Sides — 68-09
Economizer End — 68-09 (except power exhaust units 108-09)
For smaller service and operational clearances, con-
tact Carrier Product Engineering Department.
4. Vertical discharge ducts designed to be attached to
accessory roof curb. If unit is mounted on dunnage,
support the ducts using cross braces as done on the
accessory roof curb.
5. When unit is slab mounted, locate the condensate
drain as low as possible on vertical face of base rail
at the same location as the standard condensate drain
(using factory supplied fitting). Plug factory drilled con-
densate hole.
Fig. 4A — Base Unit Dimensional Drawing; 48DJ,DK,NP/50DW,DY,NB034,044 Units
11