Carrier NP034-074 - Page 12

UNIT SIZE
WEIGHT A B C D E F G H
lb kg mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in. mm ft-in.
50DJ,DK,NP
034 5400 2449 4198 13-9
1
⁄ 4 2916 9-6
13
⁄ 16 6802 22-3
13
⁄ 16 1711 5-7
3
⁄ 8 2216 7- 3
1
⁄ 4 4428 9-0
1
⁄ 8 3762 12-4
3
⁄ 8 ——
044 6050 2744 4948 16-2
13
⁄ 16 3746 12-3
1
⁄ 2 8015 26-3
9
⁄ 16 2247 7-4
7
⁄ 16 2091 6-10
5
⁄ 16 3363 11-0
3
⁄ 8 4306 14-1
1
⁄ 2 3769 12-4
3
⁄ 8
UNIT SIZE
JK
mm ft-in. mm ft-in.
50DJ,DK,NP
034 4168 13-8
1
⁄ 16 6321 20-8
7
⁄ 8
044 4999 16-4
13
⁄ 16 7534 24-8
5
⁄ 8
LEGEND
CONN — Connection
DIM — Dimension
NOTES:
1. Dimensions in [ ] are in millimeters.
2. Center of Gravity includes economizer. Unit
weight does not include economizer.
3. Unit clearances:
Top — Do not restrict condenser fans
Control Box End — 68-09
Sides — 68-09
Economizer End — 68-09 (except power exhaust units
108-09)
For smaller service and operational clearances, con-
tact Carrier Product Engineering Department.
4. Vertical discharge ducts designed to be attached to
accessory roof curb. If unit is mounted on dunnage,
support the ducts using cross braces as done on the
accessory roof curb.
5. When unit is slab mounted, locate the condensate
drain as low as possible on vertical face of base rail
at the same location as the standard condensate drain
(using factory supplied fitting). Plug factory drilled con-
densate hole.
Fig. 4B — Base Unit Dimensional Drawing; 50DJ,DK,NP034,044 Units
12