Carrier RG56 - Self Clean and Ionizer Button; Follow Me and Smart Eye Button; Fan Speed Button; Timer ON Button

BUTTONS BUTTONS
3. BUTTONS 3. BUTTONS
1
2 7
8
9
10
11
3
4
5
6
1
2 7
8
9
10
11
3
4
5
6
FOLLOW ME / SMART EYE Button
6
7
Press tis button to select the fan speed:
AUTO LOW MED HIGH
FAN Button ( )
5
SELF CLEAN / IONIZER Button:
TIMER ON Button ( )
TIMER OFF Button ( )
Press this button to initiate the auto-on time
sequence. Each press will increase the auto-
timed setting in 30 minutes increments. When
the setting time displays 10, each press will
increase the auto-timed setting 60 minutes
increments. To cancel the auto-timed program,
simply adjust the auto-on time to 0.0.
Press this button to initiate the auto-off time
sequence. Each press will increase the auto-
timed setting in 30 minutes increments. When
the setting time displays 10, each press will
increase the auto-timed setting 60 minutes
increments. To cancel the auto-timed program,
simply adjust the auto-off time to 0.0
8
9
SLEEP Button ( )
Active/Disable sleep function. It can maintain
the most comfortable temperature and save
energy.
For the detail, see sleep operation in
USER S MANUAL.
,
,,
,,
,,
,,
Active/Disable SELF CLEAN function for each
Press.
Under SELF CLEAN mode, the air conditioner
will automatically clean and dry the evaporator
and keep it as fresh for the next operation.
Press the button more than 2 seconds, the ionizer
function will be activated, press more than 2
seconds again to disable.
When the ionizer function is initiated, the Ionizer/
Plasma Dust Collector(depending on models) is
energized and will help to remove pollen and
impurities from the air.
Disable/Active FOLLOW ME function for
each press.
When the Follow Me function is activated,
the remote display is actual temperature at
its location. The remote control will send this
signal to the air conditioner every 3 minutes
until press the FOLLOW ME button again.
The Follow Me function is not available under
DRY and FAN mode. Switch the operation mode
or turn off the unit will cancel the Follow Me
function automatically.
When press more than 2 seconds, the
SMART EYE function will be activated, press
more than 2 seconds again to disable.
Under SMART EYE mode, with the built-in infrared
sensor, the unit can detects existence of humans
in the room. If the unit keep detecting no human
activity for 30 min, it will automatically enters
standby(monitor) status in order to save electricity.
And the unit will automatically start and resume
operation if sensing human activity again.
0605
NOTE: While the unit is running under
SLEEP mode, it would be cancelled if
MODE, FAN or ON/OFF button is pressed.
G B