3
INSTALLATION
Installation Notes:
d The maximum wire size to be used in the installation is
22AWG (0.50mm2) with 0.8mm insulation
d No part of the control should be installed directly outdoors or
in a cabinet outdoors
d The control assembly base should be mounted before wires are
attached
Thermostat location:
d Approximately 5 ft. (1.5m) from floor.
d Close to or in a frequently used room, preferably on an inside
partitioning wall.
d On a section of wall without pipes or duct work.
Thermostat should NOT be mounted:
d Close to a window, on an outside wall, or next to a door lead-
ing to the outside.
d Exposed to direct light or heat from the sun, a lamp, fireplace,
or near other temperature--radiating objects which could cause
a false reading.
To Next Page
Loading...
