Need help?Do you have a question about the Carrier TRANSICOLD 05G and is the answer not in the manual?
General| Brand | Carrier |
|---|---|
| Model | TRANSICOLD 05G |
| Category | Compressor |
| Language | English |
Overview of the operation and service manual for Model 05G compressors.
Describes the open-drive reciprocating type of Model 05G compressors and their components.
Provides key specifications and data for the Model 05G compressor.
Provides a comprehensive breakdown of the compressor's internal components and systems.
Explains the function and operation of the reed-type suction and discharge valves.
Details the operation and use of the compressor's service valves for connection and isolation.
Describes the force-feed lubrication system, oil pumps, and oil pressure regulation.
Explains the function and types of unloader systems used for capacity control.
Details the operation of the hot gas bypass unloader system for capacity control.
Explains the suction cutoff unloader system used for capacity control.
Describes the pressure-actuated unloader systems and their operation.
Provides step-by-step instructions for safely removing a compressor from its installation.
Outlines procedures for replacing a compressor with a service replacement unit.
Details the process of transferring unloaders from a defective to a replacement compressor.
Provides instructions for installing a new or replacement compressor into the unit.
General guidance on preparing the compressor for disassembly and maintenance.
Steps for cleaning, inspecting, and preparing compressor parts for reassembly.
Instructions for disassembling and reassembling the cylinder head and valve plate components.
Discusses the different types of oil pumps and their bearing head assemblies.
Details the removal, disassembly, and inspection of the low profile gear oil pump.
Explains the removal, disassembly, and reassembly procedures for the gear oil pump.
Covers the removal, disassembly, inspection, and reassembly of the vane oil pump.
Instructions for disassembling and reassembling the compressor shaft seal assembly.
Details the initial steps for removing the compressor's running gear components, including bottom plate and connecting rod caps.
Provides instructions for reassembling the compressor's running gear, including bearings, pistons, and rings.
Guidance on removing, cleaning, inspecting, and installing the suction strainer.
Procedures for adding the correct oil charge to the compressor.
Instructions for installing the compressor after maintenance or replacement.
To Next Page