PREPARATION 2
REMOVE OLD THERMOSTAT 3
WIRE CONNECTIONS 4
WIRING DIAGRAMS 5
CALIBRATION 8
TEST OPERATION 9
TROUBLESHOOTING 10
CAUTION Follow Installation Instructionscarefutty.
DISCONNECT POWER TO THE HEATER -
Ak
AIR CONDITIONER BEFOREREMOVING n _, _,
THEOLD THERMOSTATAND INSTALLING
THENEW THERMOSTAT, WARNING
Replacement Components Division _) Carrier Corporation 4/01
This device complies with Part 15 of the FCC rules.
Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Page I
To Next Page
Loading...
