2-- 12
62--11362
2.2.5 Oil Pan and Oil Strainer
(7)
1. Oil Pan Mounting Screw
2. Oil Pan
3. Oil Pan Cover Gasket
4. Oil Pan Cover
5. O--ring
6. Oil Strainer
7. Oil Pan Gasket
2.2.5.a Oil Pan and Oil Strainer
1. Remove the oil pan cover (4).
2. Remove the oil pan mounting bolts (1).
3. Removetheoilpan (2) by lightlytappingtherim ofthe
pan with a wooden hammer.
4. Remove the old gaskets (3) and (7).
5. Remove the oil strainer (6) and O--ring (5).
When Reassembling
Check to see that the oil filter strainer (6) is clean.
VisuallychecktheO--ring(5),applyengineoil andinstall
it to the pick--up tube.
Install the strainer (6) and O--ring (5).
Apply gasket sealant to the oil pan side of the oil pan
gasket (7) and fit the gasket to the oil pan (2).
Installtheoilpan(2)totheengine,andtightentheoilpan
mounting bolts (1) diagonally. Avoid uneven tightening
of the oil pan mounting bolts. (Refer to Section 1.5.2
Torque Specifications)
Apply gasket sealant to the oil pan cover side of the oil
pan cover gasket (3) and fit the gasket to the oil pan
cover (4).
Install the oil pan cover (4) to the oil pan (2).
Install and tighten the oil pan cover bolts diagonally.
Avoid uneven tightening of the oil pan cover mounting
bolts. (Refer to Section 1.5.2 Torque Specifications)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...