Carrier WeatherExpert 50LC14 - Step 9 - Assemble Barometric Hood; Barometric Hood (Vertical Configuration)

26
screen into place, and then slide them back into pocket
created in the filter support (Item #1). Repeat this for each
air screen (see Fig. 27). See Fig. 28 for completed hood
assembly.
Fig. 26 — Hood Part Identification and Seal Strip
Application Areas
Fig. 27 — Outdoor Air Screen Installation
Fig. 28 — Completed Hood Assembly
Step 9 — Assemble Barometric Hood
The barometric hood can be assembled in vertical or horizontal
configuration. Figure 29 illustrates the barometric hood parts.
Fig. 29 — Barometric Hood Parts
BAROMETRIC HOOD (VERTICAL CONFIGURATION)
1. Remove the hood top panel from its shipping position on
the unit end (see Fig. 30).
Fig. 30 — Shipping Location, Vertical Units
2. Remove the side panels located in the hood parts box (see
Fig. 31).
APPLY SEAL STRIP
TO THE FRONT OF
THIS FLANGE
APPLY SEAL STRIP
TO THE BACK
OF THIS FLANGE
APPLY SEAL STRIP
TO THE BACK
OF THIS FLANGE
APPLY SEAL STRIP
TO THE BACK
OF THIS FLANGE
7
7
3
5
6
8
8
2
8
6
4
2
1
2
ITEM # DESCRIPTION QTY
1 Filter Supports 3
2 Central Retainer 3
3 Hood Top 1
4 Left Hood Side 1
5 Right Hood Side 1
6 Side Retainer 2
7 Top Diverters 2
8 Deflector 3
1. INSERT
AIR SCREEN
2. SLIDE
INTO
POSITION