7
• Install full heat exchange unit in places
where the weight of the same can be
properly and adequately borne.
The unit may fall o weak bases to cause
casualty.
• Do not mount control in places where water
splashes. Soaked control internal causes
electric shock or internal electric part fault.
Control connection shall be done in
correct mode.
Otherwise, electric shock or re
ensues. Do not pull at or wring out
control wire. Such practice causes
failures.
• Make sure that measures are taken to
guard against snowing weather.
Without eective protection, snow
will enter external air hoses to damage
furniture, cause electric shock and re
accident.
In case that certain gas gets checked
outside the unit, re accident may
ensue.
• Do no ret the device.
Electric shock or re accident may ensue.
• Distributors or service network points
shall be asked to remove or reset the unit.
Incomplete installation will cause water
leakage, electric shock and re accident.
• Do not overhaul the device unaided
by concerned specialists.
Electric shock or re accident may
ensue.
Considerations for Removing, Reinstalling/Maintaining.
Safety Considerations
To Next Page
Loading...
