Carrier XPOWER 42ADF025 - Page 63

63
System Configuration – INSTALLER LEVEL
Remote Control Functions
Ite m Configuration
Item displayed
Value Default value displayed
by infrared remote control
Default value of IDU for INVERTER
“ A” : Unit remote ID A Unit’s remote ID Unit’s remote ID
“ b” : Unit remote ID B Default to Ab (Both) Default to Ab (Both)
“ Ab”: Unit remote ID
Both
“ HP”: Heat Pump Unit Configuration Unit Configuration
“ AC”: A/C Only Defaults to Heat Pump Defaults to Heat Pump
CCN Address of the unit CCN Address of the unit
Defaults to 1
Defaults to
254
(1)
Zone Number Zone Number
Defaults to 0 Defaults to 0
GFD Number GFD Number
Defaults to 1
unable to acce pt by control
(2)
“ OF”: Start in Off Mode Auto Restart Auto Restart
“ On”: Start in last mode Defaults to “On” Defaults to “O n”
6
“ A St”
“ZONE”
0 -
2
40 in increments of 1
5
“ GFdn”
1-
2
40 in increments of 1
1
“rAdr”
2
“ UCFG”
3
“ UAdr”
1-
2
40 in increments of 1
4
(1) The remote is unable to reach a value of 254.
(2) If the unit receives one of these configuration items
we will hear a double beep (NORLMAL BEHAVIOR).