EasyManua.ls Logo

Carson DRAGSTER XL - LED Status Indicators; Factory Default Settings

Carson DRAGSTER XL
44 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
15
DRAGSTER XL Brushless-Regler
4. LED display under normal operation
Red and green LED illuminated: Training mode (Reverse travel ON)
Red and yellow LED illuminated: Racing mode (Reverse travel OFF)
Red LED flashes: Undervoltage protection on
NiCd/NiMH:
LED flashes when a battery voltage
of 4 V is reached or undershot, engine
continues to run.
Two-cell or three-cell LiPo:
LED flashes when the battery voltage
of 3.0 V per cell is reached or
undershot.
The engine continues to run, but only
on half power.
Discontinue using the vehicle and
charge the battery.
5. Controller pre-set factory defaults
Battery type Automatic LiPo battery
recognition
Motor timing Normal
Acceleration Medium
Drag brake force in neutral
throttle/brake lever position 10%
Frequency
8%
Dead Band Level 4
Braking action 30%
Throttle range 0%
Reverse limit 50%
Brake reverse travel After releasing the brake and
taking the throttle/brake lever
back out of neutral.

Table of Contents

Related product manuals