GB // 20
FAIL SAFE ADJUSTMENT
1. Set the steering stick (CH 2) to the neutral position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver will start to
flash.
4. Put the throttle trigger at the brake position, press the “F/S SET”
button, the LED should become solid.
5. For electric models, put the throttle trigger at the neutral posi-
tion when you are making the failsafe setting.
EXPLANATION OF THE FUNCTIONS
The settings are altered via the “ENTER”, “ ” and “ ” buttons.
Press “ENTER” and then
/ to choose the desired model.
There are 15 model memories available, which are shown on the
display with the numbers 1-15.
Press “ENTER” to reach the desired setting.
The following functions can be selected:
Setting “CHANNEL“ (channel selection)
Press / to chose the desired channel for which the settings are
to be made.
Setting “REV” (reverse servo direction of
rotation)
Press / and select either ON or OFF.
Function only available for channel 1-4 !!
Setting D/R (dual rate)
Dual rate increases or reduces the servo travel proportionally in
relation to the control lever travel over the entire servo travel.
Press
/ to alter the dual rate setting.
A value in the range 0 -100% can be selected.
Setting “EPA” (servo travel limiting)
The EPA function allows the servo travel (left/right) to be adjusted
separately.
Move the joystick appropriate to the selected channel in the
direction for which a setting is to be made.
The display indicates “L-EPA” or “EPA-R”.
The desired value can be adjusted via
/ in the range 0 - 120%.
Setting EXP (exponential)
This function allows a different curve to be selected for the servo
travel. As a result, the input command of the remote control is no
longer transmitted linearly 1:1 but in an exponential curve instead.
Through this one obtains a “softer touch” at the servo at the start or
in the end range.
Press
/ and choose a value of either -100% or +100%.
Press “Back” to return to the initial screen.
All newly entered values are then stored automatically.
Reset function
This function allows all functions to be reset to their factory settings.
• Turn off the transmitter
• Press and hold the “Back” button and turn on the remote control
• Release the “Back” button, after which the display shows
”DEL Model”
• Confirm with the “Enter” button
• One beep “2x beep” confirms the deletion
• Turn off the transmitter to conclude the reset function
To Next Page
Loading...
Need help?
General
