1. Turn on the receiver power. Press the SW
switch. The receiver‘s LED should start
flashing.
2. Turn on the transmitter. 3. When the LED on the receiver
becomes solid, the binding process
is completed.
BINDING THE TRANSMITTER AND RECEIVER
ATTENTION
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.
During the binding process no other transmit-
ter should be operated in the vicinity at the
same time!
SPECIFICATIONS
Transmitter Frequency 2.4 GHz
Power supply DC 4.8 - 6 V=
Receiver Power Supply DC 6.0~11.0 V
Dimensions 35 x 26 x 14 mm
It is CARSON’s policy that we strive to improve the quality of our products. Therefore CARSON may alter specifications of our products at
any time without any notice.
To Next Page
Loading...
