Carson Reflex Stick PRO - Fail Safe Adjustment; Connection from Transmitter to Receiver

CARSON Reex Stick PRO 500500046
12
GB
Fail Safe Adjustment
Connection from transmitter to receiver
1. Set the throttle and the steering stick to the
neutral position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver
will start to ash.
4. Put the throttle trigger at the brake position, press
the “F/S SET” button, the LED should become
solid.
5. For electric models, put the throttle trigger at
the neutral position when you are making the
failsafe setting.
Reex Stick Pro:
The Reex Stick Pro is tted with the „Failsafe pro +“
system. This system also has integrated low voltage
protection. As soon as the voltage is too low for safe
operation, the receiver also switches to the default
throttle failsafe setting.
on
OFF
P
R
O
P
O
R
T
A
L
I O
IT
N
IG
A
D
L
1 2 3
Attention
Keep the transmitter and receiver not over
40 cm apart when setting and binding.
2. Turn on the transmitter. 3. When the LED on the receiver
becomes solid, the binding
process is complete. The RC
system is ready.
1. Turn on the receiver power.
Press the SW switch.
The receiver’s LED should
start ashing.
During the binding process no other
transmitter should be operated in the
vicinity at the same time!