8
DAILY CLEANING PROCEDURES
CAUTION:
ELECTRIC SHOCK
HAZARD
Disconnect appliance from
electric power before cleaning.
CAUTION:
HOT SURFACE
Exposed surfaces can
be hot to the touch
and may cause burns. Allow
appliance to cool before clean-
ing.
IMPORTANT:
DO NOT spill or pour
water into controls,
control panel or wiring. Water
damage is not covered by the
warranty.
CAUTION:
Beware of sharp edg-
es with sheet metal
during cleaning process.
CAUTION:
Do not use steel wool
pads to clean cabinet.
Ferrous deposits will cause
rusting; roughness of the pad
will scratch the black powder
coating on the front door frame.
1. After all food products have been removed from the cabinet,
turn the power switches to “OFF” and allow the cabinet to
cool. If cabinet is supplied with a plug, disconnect from pow-
er prior to cleaning.
2. Remove the pan rack assemblies and clean according to
manufacturer’s directions.
3. Remove the doors from the large cabinet by flipping up and
lifting off. To remove the doors from the smaller cabinet, first
remove the front door by lifting the door up and out of the
track. Then remove metal track divider that is located be-
tween the doors. Lastly, lift the rear door up and out of the
track. Doors should be washed with a clean damp cloth and
chlorine-free detergent. Rinse thoroughly with clean damp
cloth and allow to dry. Do not use abrasive cleaners, waxes,
car polish, or substances containing strong aromatic sol-
vents or alcohol. Do not use scratch pads or steel wool on
the plastic doors. Do not use stainless steel cleaner.
4. Remove bottom heat duct and then remove the rear heat
duct in each cabinet. Using a clean damp cloth with appro-
priate cleaner (see page 9), clean the inside of the unit and
the removed parts. Wipe any residue with clean damp cloth.
Reinstall all parts when they are dry and clean.
5. Inspect and clean the areas where there are vents or filters,
making sure no water gets into the internal controls or elec-
trical areas of the cabinet.
6. Plastic control panel should be washed with a clean damp
cloth and chlorine-free detergent. Rinse thoroughly with
clean damp cloth and allow to dry. Do not use abrasive
cleaners, waxes, car polish, or substances containing strong
aromatic solvents or alcohol. Do not use stainless steel
cleaner.
To Next Page
Loading...