Carver 3600 STC Auto - User Manual

CARVER
INSTALLATION AND SERVICING
INSTRUCTIONS
FOR THE
3600 STC & 3600 STC AUTO CARAVAN HEATERS
LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE MANUFACTURERS
INSTRUCTIONS AND THE REGULATIONS IN FORCE AND ONLY USED IN A SUITABLY VENTILATED
LOCATION. READ THE INSTRUCTIONS FULLY BEFORE INSTALLING OR USING THIS APPLIANCE.
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans

Summary

Warnings and Information

General Safety and Operational Warnings

Essential safety precautions, operational guidelines, and electrical connection polarity warnings.

Connection to the Gas Supply

Gas Supply Connection Procedure

Steps for connecting the gas supply pipe, using two spanners, and checking for leaks.

Connection to the 12 V or 9 V D.C. Supply (3600 STC AUTO)

Electrical Supply Connection Steps

Procedures for connecting the 12V/9V DC supply, observing polarity, and protecting the circuit.

Testing the Heater (3600 STC)

STC Ignition and Burner Operation Test

Steps for purging air, lighting the pilot burner, and operating the main burner for the STC model.

Testing the Heater (3600 STC AUTO)

STC AUTO Ignition and Burner Operation Test

Steps for testing the pilot and main burner operation for the STC Auto model, including igniter checks.

Fault Finding

Pilot Ignition and Spark Verification

Diagnostic steps to check for spark presence and gas supply during pilot ignition.

Flame Continuity and Burner Operation

Procedures to verify the pilot flame remains alight and to test the main burner operation.

Thermocouple Checks and Control Valve

Steps to diagnose issues related to the thermocouple connection, position, and gas control valve.

Carver 3600 STC Auto Specifications

General

Voltage	230V
Frequency	50Hz
Thermostat	Yes
Overheat Protection	Yes
Fan Assisted	Yes
Mounting Type	Wall Mounted
IP Rating	IP24
Heat output	3600W
Power Output	3600W