EasyManua.ls Logo

Carver CM-2002 - Page 7

Carver CM-2002
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
_ Chapter 1
Location
Observe the following precautions when
choosing a location for the CM-ZOOZ:
Do not expose the unit to rain or
moisture.
Protect from prolonged exposure to
direct sunlight.
Avoid exposure to extreme cold or dust.
Protect from heat and allow adequate
ventilation. Place away from any direct
sources of heat such as heating vents and
radiators. Make sure that air is allowed to
circulate freely behind, beside and above
the unit. Excessive heat is a common
cause of component failure.
Do not place heavy objects on top of the
CM-ZOOZ.
Do not place any audio or VCR tapes or
computer disks near the CM-ZOOZ.They
may be erased by the magnetic fields of
the transformer.
Avoid exposure to electrostatic discharge.
..
~
If you ever accidently spill anything on
the CM-ZOOZ,unplug the power cord and
contact your dealer for service
information.
l
Care
You can gently dust off the front panel
and chassis with a soft dry cloth. Try to rub
horizontally, following the grained finish of
the front panel. Take extra care when
cleaning the window, not to leave any
scratch marks.
If you have something stubborn to
remove, use a mild dish soap or detergent
sparingly applied to a soft cloth. Do not use
alcohol, ammonia, or other strong solvents.
Connections
No special tools are required to set up
your system, just RCA patch cords and
the speaker wires.
Make sure that all of your components
are OFF before making or undoing any
connections.
Connections labeled" out" on the source
component connect to those on the
CM-ZOOZthat are labeled "in". For
example, the output from a CD player
connects to the CM-ZOOZCD input.
The CM-ZOOZTape 1 and Tape Z outputs
connect to the record inputs of your tape
decks.
Make sure that you connect left to left and
right to right. For example, the left output
from your CD player should connect to .
the left input of the CM-ZOOZ.
It will help if you tag and identify each
connection cord and speaker wire.
Whenever possible, keep the power cords
away from the patch cords and speaker
wires. This will reduce the chance of
picking up any electrical interference.
The CM-ZOOZhas some AC outlets on the
rear panel. These should only be used for
low power components such as CD
players and tape decks .
You might consider buying a good
quality surge suppressor to protect your
system from power spikes and surges.
Always turn on the CM-ZOOZafter all the
other components are on.
When turning off your system, always
turn off the CM-ZOOZfirst. This
precaution will reduce any turn-on or
turn-off noises in the speakers.
o

Related product manuals