Need help?Do you have a question about the Carver Professional pt2400 and is the answer not in the manual?
General| RMS Power per channel @ 4 Ohms | 600W |
|---|---|
| Bridged RMS Power @ 8 Ohms | 1200W |
| Input Sensitivity | 1.5V for full output |
| Signal to Noise Ratio | >100dB |
| Damping Factor | >200 |
| Frequency Response | 20Hz-20kHz |
| Total Harmonic Distortion | <0.1% |
| Dimensions | 483 x 133 x 394 mm (19 x 5.25 x 15.5 inches) |
Guide to unpacking the amplifier and checking for damage.
Activates circuitry to prevent output distortion when overdriven by 8dB.
Adjusts relative output level of the amplifier with 10-step attenuators.
Controls amplifier power and displays operational status via LEDs.
Independently powers channels and allows sequential rack power-up.
Adjusts output level and displays amplifier status via LEDs.
Configures for Dual Mono or Series Mono (Bridged) operation.
Enables circuitry to limit output distortion at the onset of clipping.
Advises on placing the amplifier away from heat and moisture for safe operation.
Details rack space requirements and secure mounting methods for the unit.
Recommends mechanical support for the rear of the amplifier in transportable racks.
Emphasizes proper ventilation for cooling and preventing overheating.
Advises on placing the amplifier away from heat and moisture for safe operation.
Details rack space requirements and secure mounting methods for the unit.
Recommends mechanical support for the rear of the amplifier in transportable racks.
Emphasizes proper ventilation for cooling and preventing overheating.
To Next Page
