CARVIN V3M User Manual

- 3 -
STEP 3
Plug in speaker to output 1 or 2, they are
both the same, both jacks are in parallel.
NOTE: For speaker setup click on
“Troubleshooting” and “Speakers”.
IMPORTANT: Do NOT turn on the
amplifier without a speaker plugged in!
STEP 4
Make sure the OHM setting is correct.
Improper setting will result in damage to
the amp!
NOTE: On the back is where you will
find the OHM setting, make sure the
speaker matches the OHM setting.
STEP 5
Set the switch in the back to 50W.
NOTE: This step is very important, if
you don’t set this to 50W setting you will
not get the correct bias setting when you
adjust it later in the procedures.

CARVIN V3M Specifications

General

Brand	CARVIN
Model	V3M
Category	Amplifier
Language	English