01/19/2008 CAS (USA) Corporation 99 Murray Hill Parkway East Rutherford, NJ 07073 CL5000-Series
Installation for Lantronix Internal
Ethernet
1. The internal Ethernet installation kit will contain an Ethernet I/O
board, internal Ethernet board, crossover Ethernet cable, power and
indicator lights cable, and the necessary hardware. Remove the top
cover of the CL5000. There are four chrome screws on the top. One is
under the sealing plate. On the bottom of the scale there are four
brass colored screws along the front edge of the scale. There are
also two at the rear edge of the scale, one in each corner.
2. If the scale has the old style Ethernet set up then the slot PCB as
shown in the left hand picture must be removed. Disconnect the ribbon cable
from the board. Unplug the other end of the ribbon cable from the main
board where it is plugged into the NETWORK BOARD connector. Remove the
cable.
To Next Page
Need help?
General
